Ø  Usually, main power cable dimension is 2x1.5mm². To prevent damage from overheating caused by overload, it is essential to take0.75mm²/18# wire as main power cable if necessary. Cable length between power and module should not exceed2m. If over2m, it will increase total power consumption.

Ø  Take method 1 for installation (single end power supply), maximum is 20 PCS. Take method 2 for installation (both ends power supply), maximum is 30 PCS. (No over-connecting).

Ø  Take off release paper from adhesive tape at the back of modules. Stick modules inside light box or advertising signage for initial setting. Fix module by 1piece of ST2.9x10 mmself tapping screw or by glass glue at both sides of module.

Ø  Standard connection number is 20pcs for each string; Cut into each piece as to actual requirement.

Ø  During the connection, use diagonal pliers to cut off power cable between modules, peel off the plastic around10mm, wire the cables and then connect them to their respective isolation port (the white-red cable heads to positive, the white cable for negative). Do remember check the conductivity and reliability of the cable after the connection, generally, they can't be pulled out of the port by middling force.

Ø  Peel off the cable coat by10mm(around) then connect then into isolation port if there are extra cables for the string-end module.

Ø  Make sure that the waterproof and anti-corrosive reliability; grease some silicon glue (neutral glass glue or waterproof glue) into the connection port for further protection.

Ø  Don’t touch the product when they are electrified.

Ø  Advise to use SMPS with related safety certificate (with short circuit protection, overload protection and over-current protection)